Hold-It! Positioning Soldering Clay IN STOCK SHIPPING END OF JAN
OUT OF STOCK CURRENTLY - Will open pre-orders when it's available again. Should be Mid to End of FEB.
Sourcing/Supply chain issues are causing delays for packaging and the clay materials to make.
The magic clay that holds your small parts while soldering silver and karat golds. Difficult soldering set ups become a dream with using this clay. It will stay in its molded form and provide some heat protection from delicate soldered areas. It is NOT a heat shield to protect stones. While it will not disintegrate, it will get burnt slightly from direct flame. This is reusable for up to 2 or 3 times with reconstituting in warm water. After it cools and the piece is cool, it breaks off and any tiny bits left can be washed off with soap and water with a toothbrush. The still soft bits can be reused back in the jar. Dried out pieces can be saved to reconstitute later.VIDEOS of it in use on INSTAGRAM @reneefordmetals.
NOT FOR USE WITH PLATINUM OR PLATINUM GROUP METALS——Platinum group metals don't like carbon and this produces carbon. (Platinum, Palladium, karat golds with Palladium or Platinum, Rhodium or Iridium.)
Does not contain asbestos or other harmful additives. Contains aluminum oxide, silica and water. It does burn with prolonged intense heat and produce carbon.
Comes shipped in an 8oz jar but will weigh as approximately 6oz of clay. The clay does not come to the rim but will be about 2/3 full.
Jar must be kept closed TIGHTLY with inner SEAL intact. Do not throw away self sealing lid liner. It needs to stay closed when not in use to keep the clay from drying out. The clay is EARTH made so natural microbes exist in the clay. A mildew smell or minor molding may occur because of the moisture content and a natural ingredient base.